Rechargeable LED Emergency light

How to make Rechargeable LED Emergency light at home

Rechargeable LED

Emergency Light

Usually a rechargeable light is used after the power cut off. Darkness comes down after the light of day. Then there is a need of light everywhere in the village, city. The village power supply is not so much better than the city. After the power supply is cut off, the rechargeable light is needed.

How to create a rechargeable LED light at home?

To create a rechargeable LED light at home, there will be some things to bring from the market. The names are given below.

A plastic jar(Electrical wiring pvc board), six-volt battery, six-voltage LED light, Switch, Female Charging Jack, Wires will be required in some quantities.

Switch

Switch

Switch

Switch

Switch

The procedure to create this rechargeable LED light is discussed below.

• Very simple connection :-

1. Electrical wiring pvc board.
2. LED strip lights
3. Switch
4. Charging socket
5. Wires

The connection I'm talking about here is very simple. Positive and Negative are all electronics devices. For this switch, the batteries, the LED's will have to put two wire. Only four connections will be put in the battery.

First comes the positive and negative battery connection from Female Socket. Battery connection with LED light positives and negatives.

Female Socket

Female Socket

Female Socket

Female Socket

• Connection with charging LED :-

1. Electrical wiring pvc board.
2. LED strip lights.
3. Switch.
4. Charging socket.
5. Wires.
6. 4007 diode.
7. 100 ohm Resistor.
8. Charging indicator LED light.

This connection is complicated. But not too complicated. Here only a small LED needs, a Resistance and a Diode. Diode and Resistance adding to the charging socket positive. One side of the Resistance can be Charging indicator LED positive. Negative of Charging indicator LED and charging sockets will be linked together. The Diode can be switching positively one side and on the other side of the switch will be LED strip lights. Negative LED strip lights and Charging Socket will be added. Connection with one end of the Diode and one end of the LED strip lights will be connection with the Battery.

six-voltage LED light

six-voltage LED light

plastic jar

plastic jar

plastic jar

You can do many types of connections in this Rechargeable LED light. You can make more lights by adding more electronics parts. Lights can be controlled by adding Variables Resistor.

DC Battery

DC Battery

DC Battery

DC Battery

Some things to know about-

Connection must be done correctly (Positive and Negative).

Battery volts will be higher than LED's.

Do not connect another with a connection.

Charging socket

Charging socket

Rechargeable LED
Charging socket

2.0 mm/0.6 mm 
DC Power Jack Socket
Charging Connector Port

Rechargeable LED

Rechargeable LED